How does it work?

 

Step 1  Clean the surface

 

Clean, wipe the window frame surface with warm water with a small amount of detergent to remove dust, dirt and grease that may stop the tape from sticking. 

Tips allow the window frame to time to dry to help the adhesive tape to stick

Step 2   Measure the window

 

With a tape measure start to measure the distance from the start of the inside of the window you are insulating to the nearest flat surface. 

Measure side to side and then top to bottom. 

Example 980mm x 1120mm

(0.98m  x  1.12m) or (98 cm x 112 cm) 

 

Step 3   Apply the tape

 

When the window frame is dry 

Start to apply the double sided self-adhesive tape to the window frame

You measured earlier using your measurements. 

Example 980mm x 1120mm 

Use your knife or scissors to trim any excess you may have. 

 

Step 4   Apply the film

 

When youre ready to apply the insulation film remove the tape backing so the film will stick. Hold the piece of film up to the window and slowly start to stick the film to the tape 

TIP  apply one side first and pull the film to reduce creases and stick to the opposite side and the top and bottom.

 

Step 5   Hairdryer

And to finish point the hairdryer to the film med heat, you will see the film go tight and hopefully wrinkle free!

 

an easy DIY fix!

this kit comes with easy to follow instructions

 

This Window Insulation Kit is a DIY solution that lets create an extra layer of insulation on the windows. It consists of a clear plastic film and a double-sided tape that can easily apply to any window frame.

The film shrinks when heated with a hairdryer, creating a tight seal that prevents cold air from entering and warm air from escaping. The film is transparent and does not reduce the amount of light or visibility through the window. 

There is a little more to it than that! that`s the basics and there are lots of tips and addition items that come with your kit.
an easy fix with some basic DIY required.