How does it work?
Step 1 Clean the surface
Clean, wipe the window frame surface
with warm water with a small amount of detergent to remove dust,
dirt and grease that may stop the tape from sticking.
Tips allow the window frame to
time to dry to help the adhesive tape to stick
Step 2 Measure the
window
With a tape measure start to measure
the distance from the start of the inside of the window you are
insulating to the nearest flat surface.
Measure side to side and then top to
bottom.
Example
980mm x 1120mm
(0.98m x
1.12m) or (98 cm x 112 cm)
Step 3 Apply the tape
When the window frame is dry
Start to apply the double sided
self-adhesive tape to the window frame
You measured earlier using your
measurements.
Example
980mm x 1120mm
Use your knife or scissors to trim
any excess you may have.
Step 4 Apply the film
When youre ready to apply the
insulation film remove the tape backing so the film will stick.
Hold the piece of film up to the window and slowly start to
stick the film to the tape
TIP
apply one side first and pull the film to reduce creases and
stick to the opposite side and the top and bottom.
Step 5 Hairdryer
And to finish point the hairdryer
to the film med heat, you will see the film go tight and
hopefully wrinkle free!
an easy DIY
fix!
this kit comes with easy to follow instructions
This Window Insulation Kit is
a DIY solution that lets create an extra layer of insulation on
the windows. It consists of a clear plastic film and a
double-sided tape that can easily apply to any window frame.
The film shrinks when heated with a
hairdryer, creating a tight seal that prevents cold air from
entering and warm air from escaping. The film is transparent and
does not reduce the amount of light or visibility through the
window.
There is a little more to it than
that! that's the basics and there are lots of tips and addition
items that come with your kit.
an easy fix with some basic DIY required.
Whats in your window insulation kit? 1 x Easy to follow installation DIY guide. 1 x Sheet Clear shrink insulation film.(1.57m x 1.82m) each pack. (Insulates 2 Windows up to 1m x 1,5m approx)
1 x Roll double sided adhesive tape 12.7mm x 10m length. Each roll will stick up to 2 windows.!
